Relay module; Nominal input voltage: 115 VAC; 1 changeover contact; Limiting continuous current: 16 A; Red status indicator; Module width: 15 mm; 2,50 mm²; gray

Safety information:
A separator plate (e.g., 209-191) must be used for voltages greater than 250 V between adjacent relay modules and for compliance with the reinforced insulation requirements.

Note:
Reinforced insulation between coil and contacts
To protect the relay coils and contacts, inductive loads must be dampened with an effective protection circuit.

Technical data:
Control Circuit:
Nominal input voltage UN AC 115 V
Input voltage range ±10 %
Nominal input current at UN 8 mA

Load circuit:
Number of changeover/switchover contacts 1
Contact material (relay) AgNi 90/10
Limiting continuous current 16 A
Inrush current (resistive) max. (AC) 30 A / 4 s
Switching voltage (max.) AC 250 V
Switching power (resistive) max. AC 4000 VA; DC (see load limit curve)
Switching capacity AC-15: 6 A / AC 250 V; DC-13: 2 A / DC 24 V
Recommended minimum load 12 V / 10 mA
Pull-in time (typ.) 10ms
Drop-out time (typ.) 35ms
Bounce time (typ.) 6ms
Electrical life (NO; resistive load; 23 °C) 30 x 10³ switching operations
Mechanical life 5 x 10⁶ switching operations
Switching frequency with/without load (max.) 6 min-1 / 600 min-1

Signaling:
Status indicator Red LED

Relay module; Nominal input voltage: 115 VAC; 1 changeover contact; Limiting continuous current: 16 A; Red status indicator; Module width: 15 mm; 2,50 mm²; gray

Safety information:
A separator plate (e.g., 209-191) must be used for voltages greater than 250 V between adjacent relay modules and for compliance with the reinforced insulation requirements.

Note:
Reinforced insulation between coil and contacts
To protect the relay coils and contacts, inductive loads must be dampened with an effective protection circuit.

Technical data:
Control Circuit:
Nominal input voltage UN AC 115 V
Input voltage range ±10 %
Nominal input current at UN 8 mA

Load circuit:
Number of changeover/switchover contacts 1
Contact material (relay) AgNi 90/10
Limiting continuous current 16 A
Inrush current (resistive) max. (AC) 30 A / 4 s
Switching voltage (max.) AC 250 V
Switching power (resistive) max. AC 4000 VA; DC (see load limit curve)
Switching capacity AC-15: 6 A / AC 250 V; DC-13: 2 A / DC 24 V
Recommended minimum load 12 V / 10 mA
Pull-in time (typ.) 10ms
Drop-out time (typ.) 35ms
Bounce time (typ.) 6ms
Electrical life (NO; resistive load; 23 °C) 30 x 10³ switching operations
Mechanical life 5 x 10⁶ switching operations
Switching frequency with/without load (max.) 6 min-1 / 600 min-1

Signaling:
Status indicator Red LED